++APAR(TR81016)
       /*

  LOG ENTRY: PR23015

  FUNCTION:  Allow z/OS 3.1 JES2 stubs to assemble properly


  NOTE1: INSTALLATION INSTRUCTIONS

         If this APAR is not applied to the execution
         library, the affected module(s) must be copied from
         the target library where the APAR was applied.

  NOTE2: ACTIVATION INSTRUCTIONS

         In order for this service to take effect,
         an LLA REFRESH should be performed followed by the
         IPL of the z/OS 3.1 system.

  NOTE3: GENERAL NOTES

         The APARs listed in the PRE list below may be
         removed from the list if it is desired to only install
         this specific fix. The fix is NOT dependent on any other
         APAR.

         Please use the ThruPut Manager CHECKSUM facility to
         verify this APAR has been typed in correctly.

         The CHECKSUM facility can be used by invoking the
         $CHKSUM ISPF EDIT Macro provided in the INSTALL
         library on the distribution tape.

         This facility is described in the ThruPut Manager
         System Programming Guide.

       */.
++VER (Z038) FMID(TTM8100)
              PRE(TMT8104).
++SRCUPD (DTMJ2MV8).
./ CHANGE NAME=DTMJ2MV8
         AIF   (&J2PLVL EQ &ZOS31).SP530      z/OS 3.1         TR81016  04420036
APAR1    DC    CL4'1016'                                       TR81016  53120000
++SRCUPD (DTMJ2SV8).
./ CHANGE NAME=DTMJ2SV8
         AIF   (&J2PLVL EQ &ZOS31).SP530      z/OS 3.1         TR81016  03600035
APAR1    DC    CL4'1016'                                       TR81016  28610000